Retentive Thermal Memory
Remembers the thermal condition of the motor even if control power is lost. Thermal Register is adjusted for Off-Time when power is resumed.

Learned Dynamic Reset
Overload Trip will not reset unless motor has regained enough thermal capacity based on learned motor starting profiles.

Phase Loss/Sequence Protection
Trips on any phase under 20% of Voltage. Sequence selectable A-B-C, C-A-B or Off.

Over Voltage Trip
Any phase voltage over trip level Of or 1-10% of set voltage, w/1-20 sec. delay.

Load Monitor (True Motor Power)
Under or Over kW trip or alarm Off, or 20-100% motor kW, w/1-20 sec. delay.

Equipment Ground Fault Protection
Electronic Residual current protection method, no additional CTs needed Setting: Off, 5-90% of CT w/1-60 sec. delay.

Starts-per-Hour Lockout
Programmable maximum starts-per-hour to prevent exceeding motor limits. Setting: Off or 0-10 start / Hr.

Programmable Service Factor
Service Factor setting automatically adjusts other settings to compensate. Adjustment Range: 1.0-1.15 SF.

Over-Current Trip
Electronic Shear-Pin / Shock Relay Setting: Off or 50-300% FLA w/1-20 sec. dela.y

Under Voltage Trip on Startup
Off, or 1-30% of set voltage 1-180 second startup time.

Power Factor Monitor
Leading or Lagging PF, trip or alarm Off, or 0.01-1.00, lead or Lag w/1-20 sec. delay.

Short Circuit / Shorted Load
Peak Current quick trip (electronic fuse) Trip level: Off or 800-1400% FLA, with .1-.5 sec. delay.

Minimum Time Between Starts
Used with or without Start-per-Hour protection to prevent short cycling of motor Setting: Off or 1-60 minutes between starts.

Dual Overload Curve Settings for RV start
Start Curve can be set to Class 5-30 Run Curve can be set to Class 5-30 Automatic Full Speed detection and change over.

Current Imbalance Protection
Provides monitoring of phase-to-phase current levels and trips if imbalance exceeds setting. Setting: Off or 1-30% FLA w/1-20 sec. delay.

Under-Current Trip
Load-Loss /Loss of Prime protection Setting: Of or 10-90% FLA w/1-60 sec. delay.

Under Voltage Trip at Full Speed
Off, or 1-30% of set voltage 1-20 second trip delay.

Coast-Down Timer
Back Spin or Anti-Wind Milling protection Prevents Restart after Stop Command Time Setting: Off or 1-60 min.

Restart Delay Timer
Programmable delay for restarting after a power failure for use in multiple installations. Setting: 0-999 sec.